substitutions:
  device_name: esp32-h2c-camera
  friendly_name: "3D Printer Camera"

esphome:
  name: ${device_name}
  friendly_name: ${friendly_name}

esp32:
  board: esp32-s3-devkitc-1
  framework:
    type: esp-idf

# Required for ESP32 camera buffering.
psram:
  mode: octal

logger:

api:
  encryption:
    key: !secret api_encryption_key

ota:
  - platform: esphome
    password: !secret ota_password

wifi:
  ssid: !secret wifi_iot_ssid
  password: !secret wifi_password
  ap:
    ssid: "${friendly_name} Fallback"
    password: !secret fallback_password

captive_portal:

web_server:
  port: 80

i2c:
  - id: camera_i2c
    sda: GPIO8
    scl: GPIO9
    scan: false

esp32_camera:
  name: "${friendly_name}"
  external_clock:
    pin: GPIO5
    frequency: 20MHz
  i2c_id: camera_i2c
  data_pins: [GPIO16, GPIO18, GPIO21, GPIO17, GPIO14, GPIO7, GPIO6, GPIO4]
  vsync_pin: GPIO1
  href_pin: GPIO2
  pixel_clock_pin: GPIO15

  # Start conservative for reliability; increase later if stable.
  resolution: 640x480
  jpeg_quality: 12
  max_framerate: 10 fps
  idle_framerate: 0.2 fps
  frame_buffer_count: 1

  # Common orientation defaults for this module.
  vertical_flip: false
  horizontal_mirror: false
  brightness: 1

# Camera endpoints:
# Stream:   http://<ip>:8080
# Snapshot: http://<ip>:8081
esp32_camera_web_server:
  - port: 8080
    mode: stream
  - port: 8081
    mode: snapshot

switch:
  # DFRobot board IR illumination control pin.
  - platform: gpio
    name: "${friendly_name} IR LED"
    pin: GPIO47
    restore_mode: ALWAYS_OFF

sensor:
  - platform: wifi_signal
    name: "${friendly_name} WiFi Signal"
    update_interval: 60s

  - platform: uptime
    name: "${friendly_name} Uptime"

button:
  - platform: restart
    name: "${friendly_name} Restart"