psram:
  mode: octal
  speed: 80MHz

i2c:
  sda: 8
  scl: 9

# CH422G I/O expander (Waveshare uses it for LCD reset/backlight/touch reset)
ch422g:
  - id: ch422g_hub

# --- Backlight control (CH422G IO2 is common for Waveshare LCD BL) ---
switch:
  - platform: gpio
    name: "LCD Backlight Raw"
    id: lcd_backlight_raw
    restore_mode: ALWAYS_ON
    pin:
      ch422g: ch422g_hub
      number: 2
      mode:
        output: true

# A nicer HA-exposed control (so you can also automate it from HA)
light:
  - platform: binary
    name: "HA Remote Backlight"
    output: lcd_backlight_out
    id: ha_remote_backlight

output:
  - platform: template
    id: lcd_backlight_out
    type: binary
    write_action:
      - if:
          condition:
            lambda: return state;
          then:
            - switch.turn_on: lcd_backlight_raw
          else:
            - switch.turn_off: lcd_backlight_raw

# --- Inactivity tracking (dim/off + wake on touch) ---
globals:
  - id: last_activity_ms
    type: uint32_t
    restore_value: no
    initial_value: '0'

interval:
  - interval: 1s
    then:
      - lambda: |-
          if (id(last_activity_ms) == 0) id(last_activity_ms) = millis();

      # Turn off backlight ONCE at 2 minutes idle.
      - if:
          condition:
            lambda: |-
              const uint32_t idle_s = (millis() - id(last_activity_ms)) / 1000;
              return idle_s == 120;
          then:
            - light.turn_off: ha_remote_backlight

# --- Display ---
display:
  - platform: mipi_rgb
    model: ESP32-S3-TOUCH-LCD-7-800X480
    id: main_display
    update_interval: never
    auto_clear_enabled: false
    reset_pin:
      ch422g: ch422g_hub
      number: 3
      mode:
        output: true

# --- Touch ---
touchscreen:
  platform: gt911
  id: touch_panel
  update_interval: 120ms
  reset_pin:
    ch422g: ch422g_hub
    number: 1
    mode:
      output: true
  on_touch:
    then:
      - lambda: |-
          id(last_activity_ms) = millis();
      - light.turn_on: ha_remote_backlight

# --- LVGL UI ---
# Note: On ESP32-S3-Touch-LCD-7, GPIO14 is used by the RGB display bus,
# so it cannot be reused as ADC for battery telemetry in this display mode.